Ada MP-1 Owner's Manual

For best results when running with a power amplifier • Run volume control higher on your power amp • Run Output level control as low as poss

The MP-1 is monitored at four points along the signal path for clipping via the front panel CLIP LEDS. If the LEDS flash on and off while you play the

FACTORY PRESETS 1 Marshall 36 Humbuck 50 Watt Clean 2 Notched Grind 37 Sgl. Coil 50 Watt Stock 3 Liquid Grind 38 Sgl. Coil 50 Watt Hot Rod 4 Edge

MIDI SELECT MIDI CHANNEL 1. Press the MIDI CHNL button on the front panel of your MP-1. It will light up. 2. Use the up or down arrow buttons to se

your computer or sequencer. If transferring data from one MP-l to another, use one MIDI cable at a time to avoid MIDI feedback. SINGLE PROGRAM SAVE:

DUAL FUNCTION CONTROLS: IN PLAY MODE: BANK Enter a bank number (0 to 12) by using the up or down arrows. After bank selection, you must select the &

DICTIONARY HIDDEN COMMANDS: The MP-1's hidden commands may be reviewed at any time while in play mode by pressing and holding the BANK button in

SOFTWARE VERSION The MP-1 displays the current installed software version during power-up. It is a three numeral read-out which is displayed just pri

BATTERY REPLACEMENT The MP-1 uses a 3-volt Lithium battery which maintains power for program storage while the MP-1 is unplugged from an AC supply. E

DIRECT INPUT When using the MP-1 direct into a P A or recordingconsole and using distorted tones it may be necessary to use an outboard EQ to "e

MIDI IMPLEMENTATION FUNCTION TRANSMITTED RECOGNIZED CHANNEL default changed 1-16, OFF, ALL 1-16, OFF, ALL 1-16, OFF, ALL 1-16, OFF, ALL PROGRAM C

“Chorus Clean” - #90 “Dry Clean” - 91 Overdrive 1: 2.8 Overdrive 1: 2.8 Overdrive 2: 3.2 Overdrive 2: 3.2 Bass: 16 Bass: 16 Mid:

Page 17 MP-1 Program chart OD1 OD2 MASTER BASS MID TREBLE PRESENCE LOOP DEPTH RATE MEMORY OD1 OD2 MASTER BASS MID TREBLE PRESENC

“Shimmery Chorus” - #96 “Classic Rock” - #97 Overdrive 1: 2.8 Overdrive 1: 4.4 Overdrive 2: 3.2 Overdrive 2: 3.6 Bass: 16 Bass: 16

Originally written by ADA SIGNAL PROCESSORS, INC. Scanned and edited by Jur at 12th of may 2002. Original ADA logo edited and rendered by Barend Onne

CONTENTS INTRODUCTION FEATURES PRECAUTIONS QUICK START GUIDE SET UP AUDIOPATCH EFFECT LOOP PATCH MIDIPATCH SYSTEM POWER UP ACCESSING PROGRAMS P

INTRODUCTION Thank you for purchasing the ADA MP-1 MIDI Programmable Tube Preamp. You now own the most tonally flexible and technologically advanced g

PRECAUTIONS WARNING: To prevent fire or shock hazard, do not expose this appliance to rain or moisture. Locate the MP-l out of direct sunlight. Avoi

SET UP AUDIO PATCH For best results always use high quality cables. Keep all cables as short as possible, and route cables neatly. Keep AC, MIDI, and

SYSTEM POWER-UP With any audio system you should apply AC power to components in the order of signal flow. Turn on the first device in the audio chai